Chapter 10 VLAN
VES1724-56 User’s Guide
134
10.5.3 Configure a Static VLAN
Use this screen to configure and view 802.1Q VLAN parameters for the Switch. See Section 10.1 on
page 129 for more information on static VLAN. To configure a static VLAN, click Static VLAN in the
VLAN Status screen to display the screen as shown next.
Figure 74 Advanced Application > VLAN > Static VLAN
The following table describes the related labels in this screen.
Table 50 Advanced Application > VLAN > Static VLAN
LABEL DESCRIPTION
ACTIVE Select this check box to activate the VLAN settings.
Name Enter a descriptive name for the VLAN group for identification purposes. This name consists
of up to 64 printable characters.
VLAN Group ID Enter the VLAN ID for this static entry; the valid range is between 1 and 4094.
VLAN Profile Select a VLAN profile in which you can specify the action the Switch takes on incoming
unknown multicast frames and whether to enable MAC address learning for this VLAN.
Port The port number identifies the port you are configuring.
To Next Page
Loading...
