ZyXEL Communications VES1724-56 - Configuring SNMP

Chapter 37 Access Control
VES1724-56 User’s Guide
342
37.3.4 Configuring SNMP
Click Management > Access Control > SNMP to view the screen as shown. Use this screen to
configure your SNMP settings.
Figure 215 Management > Access Control > SNMP
The following table describes the labels in this screen.
xdsl2LinePerfCorrectedT
hreshXtur
1.3.6.1.2.1.10.251.0.14 This trap is sent when the number of
corrected blocks (FEC events) in CPE side
exceeds the threshold.
xdsl2LinePerfFailedFullIni
tThresh
1.3.6.1.2.1.10.251.0.15 This trap is sent when the number of full
initialization failure times for an ADSL/
ADSL2/ADSL2+ line exceeds the threshold.
xdsl2LinePerfFailedShortI
nitThresh
1.3.6.1.2.1.10.251.0.16 This trap is sent when the number of short
initialization failure times for an ADSL/
ADSL2/ADSL2+ line exceeds the threshold.
others xdsl2LineStatusChangeX
tuc
1.3.6.1.2.1.10.251.0.17 This trap is sent when the Switch detects
that a DSL line’s status changes.
xdsl2LineStatusChangeX
tur
1.3.6.1.2.1.10.251.0.18 This trap is sent when a DSL line’s status
changes at the CPE end.
Table 161 SNMP VDSL Traps (continued)
OPTION OBJECT LABEL OBJECT ID DESCRIPTION
Table 162 Management > Access Control > SNMP
LABEL DESCRIPTION
General Setting Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP version 1.