Chapter 8 Basic Setting
VES1724-56 User’s Guide
88
8.13 IPv6 Setup
Use this screen to configure Switch’s management IPv6 addresses. Click Basic Setting > IP Setup
> IPv6 Setup to display the configuration screen. See Section 8.6 on page 76 for more
information about IPv6.
Figure 46 Basic Setting > IPv6 Setup
Modem Code This field displays the chip firmware version number of the CPE device connected to this port.
NA displays if it is not available.
FW Version This field displays the firmware version number of the DSL CPE device connected to this port.
NA displays if it is not available.
Wireless This field displays whether or not the CPE device has the wireless function enabled. NA
displays if it is not available.
VDSL Template This field displays the name of the VDSL profile applied to this DSL connection.
Line Profile This field displays the name of the line profile applied to this DSL connection.
Channel Profile This field displays the name of the channel profile applied to this DSL connection.
Inm Profile This field displays the name of the INM profile applied to this DSL connection.
Table 20 Basic Setting > CPE Port Status (continued)
LABEL DESCRIPTION
To Next Page
Loading...
