Chapter 35 DHCP
VES1724-56 User’s Guide
318
35.5 Configuring DHCP VLAN Settings
Use this screen to configure your DHCP settings based on the VLAN domain of the DHCP clients.
Click IP Application > DHCP in the navigation panel, then click the VLAN link In the DHCP
Status screen that displays.
Note: You must set up a management IP address for each VLAN that you want to
configure DHCP settings for on the Switch.
See Section 8.7 on page 79 for information on how to set up management IP addresses for VLANs.
Note: This screen is not available if you have enabled DHCP Relay globally in the IP
Application > DHCP > Global > DHCP Relay screen.
You can additionally configure whether to add/replace DHCP relay option 82 tags on a per-port
basis in the Basic Setting > Port Setup screen (see Section 8.9 on page 82).
Figure 201 IP Application > DHCP > VLAN
To Next Page
Loading...
