Chapter 23 VLAN Stacking
VES1724-56 User’s Guide
215
23.4.3 Port-based InnerQ
Port-based InnerQ allows you to add a customer VLAN (the inner tag) tag to untagged incoming
frames before adding the service provider’s VLAN tag (the outer tag) and forwarding them out. This
feature is not applicable on a tunnel port.
Click Port-based InnerQ in the Advanced Application > VLAN Stacking screen to display the
screen as shown.
Figure 129 VLAN Stacking > Port-based InnerQ
Active This shows whether this rule is activated or not.
Name This is the descriptive name for this rule.
Port This is the port number to which this rule is applied.
CVID This is the customer VLAN ID in the incoming packets.
SPVID This is the service provider’s VLAN ID that adds to the packets from the subscribers.
Priority This is the service provider’s priority level in the packets.
Delete Check the rule(s) that you want to remove in the Delete column and then click the Delete button.
Cancel Click Cancel to clear the Delete check boxes.
Paging Select Prev or Next to show the previous/next screen or select a page number from the drop-
down list box to display a specific page if all entries cannot be seen in one screen.
Table 93 VLAN Stacking > Selective QinQ (continued)
LABEL DESCRIPTION
To Next Page
Loading...
