Chapter 9 VDSL Setup
VES1724-56 User’s Guide
125
The following table describes the labels in this screen.
9.5 VDSL Bonding Setup
VDSL port bonding allows you to connect subscribers to an ISP using data streams spread
over multiple DSL lines. The total available bandwidth for the subscriber then becomes
the sum of the bandwidth available for each of the subscriber’s line connections.
The next figure shows a subscriber using port bonding on two DSL lines between a CPE
that supports VDSL bonding (A) (using a Y-connector) and the Switch to connect to the
Internet.
Figure 68 VDSL Port Bonding Example
Table 45 VDSL Channel Alarm Profile Setup
LABEL DESCRIPTION
Name Enter a descriptive name for identification purposes.
VTUC Configure the thresholds in this column for the Switch (VTUC).
VTUR Configure the thresholds in this column for CPE devices (VTUR).
15Min
CodeViolation
Threshold
Enter the number of Code Violation (incorrect cyclic redundancy check) that are permitted
to occur within 15 minutes.
15Min Corrected
Blocks Threshold
Enter the number of error blocks that can be corrected within 15 minutes.
Add Click Add to save the new rule to the switch. It then displays in the summary table at the
bottom of the screen.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to clear the fields to the factory defaults.
Name This field displays the descriptive name for the VDSL channel alarm profile.
CV This field displays the number of Code Violation (incorrect cyclic redundancy check) that
are permitted to occur within 15 minutes.
Corrected This field displays the number of error blocks that can be corrected within 15 minutes.
Applied Ports This field displays the VDSL port number(s) to which this profile is applied.
Delete Check the rule(s) that you want to remove in the Delete column and then click the
Delete button.
Cancel Click Cancel to clear the selected checkboxes in the Delete column.
To Next Page
Loading...
