Chapter 9 VDSL Setup
VES1724-56 User’s Guide
126
Click VDSL Setup and VDSL Bonding Setup in the navigation panel to display the
screen as shown. Use this screen to view, add, edit, and delete VDSL port bonding
groups.
Figure 69 VDSL Bonding Setup
The following table describes the labels in this screen.
Table 46 VDSL Bonding Setup
LABEL DESCRIPTION
Active Select the check box to enable this group.
Name Enter a descriptive name for this group.
Group ID Select an identifier number for this group from the drop-down list box.
Port Select a pair of ports to be used by this DSL line group.
A port can be in up to one bonding group at a time.
Template Profile Select Mode 1 and a single template profile to set a total data rate for the entire
bonding group. The total data rate is divided equally for each port.
Select Mode 2 and select a separate template profile for each individual port in
the bonding group to set each port's data rate independently.
Transmission
Mode
Select a transmission standard (ATM for ADSL or PTM for VDSL) to use for this
group.
Add Click Add to save the new group of DSL lines on which to use port bonding. It
then displays in the summary table at the bottom of the screen.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to clear the fields to the factory defaults.
Group ID This field displays a VDSL bonding group’s ID. Click the ID to modify this group’s
settings.
Name This field displays the name of the group.
Active This field displays whether this group is enabled (Yes) or not (No).
Port This field displays the port numbers in this group.
Protocol This field displays the transmission mode protocol (PTM or ATM) this group
uses.
To Next Page
Loading...
