ZyXEL Communications VES1724-56 - Link Aggregation Setting

Chapter 17 Link Aggregation
VES1724-56 User’s Guide
182
17.4 Link Aggregation Setting
Click Advanced Application > Link Aggregation > Link Aggregation Setting to display the
screen shown next. See Section 17.1 on page 180 for more information on link aggregation.
Figure 108 Advanced Application > Link Aggregation > Link Aggregation Setting
The following table describes the labels in this screen.
Table 75 Advanced Application > Link Aggregation > Link Aggregation Setting
LABEL DESCRIPTION
Port Selection
criteria
Specify the way to choose a port in the trunk group (multiple ports) to transmit/receive
packets for different type of traffic. Select one of the following criteria for the port selection.
Source MAC Address: Uses packets’ source MAC address as the criteria.
Destination MAC Address: Uses packets’ destination MAC address as the criteria.
Source+Destination MAC Address: Uses packets’ both source and destination MAC
address as the criteria.
Source IP Address: Uses packets’ source IP address as the criteria. This can be only used
for IPv4 packets.
Destination IP Address: Uses packets’ destination IP address as the criteria. This can be
only used for IPv4 packets.
Source+Destination IP Address: Uses packets’ both source and destination IP address as
the criteria.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple
ports.
Active Select this option to activate a trunk group.
Port This field displays the port number.
Group Select the trunk group to which a port belongs.