Chapter 23 VLAN Stacking
VES1724-56 User’s Guide
211
23.4 Configuring VLAN Stacking
Click Advanced Application > VLAN Stacking to display the screen as shown.
Note: You can not enable VLAN mapping and VLAN stacking at the same time.
Figure 126 Advanced Application > VLAN Stacking
The following table describes the labels in this screen.
Table 91 Advanced Application > VLAN Stacking
LABEL DESCRIPTION
Active Select this to enable VLAN stacking on the Switch.
Port The port number identifies the port you are configuring.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
To Next Page
Loading...
