Chapter 29 VLAN Mapping
VES1724-56 User’s Guide
279
29.2 Enabling VLAN Mapping
Click Advanced Application and then VLAN Mapping in the navigation panel to display the
screen as shown.
Figure 171 VLAN Mapping
The following table describes the labels in this screen.
Table 125 VLAN Mapping
LABEL DESCRIPTION
Active Select this option to enable VLAN mapping on the Switch.
Port This field displays the port number.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable the VLAN mapping feature on this port. Clear this check box to
disable the VLAN mapping feature.
Drop Miss Select this check box to discard the incoming packets that do not match any VLAN mapping rules
on this port. Otherwise, clear the check box to forward the packets without replacing the VLAN
tag.
The Switch forwards any outgoing packets even when they do not match a VLAN mapping rule.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
