Chapter 8 Basic Setting
VES1724-56 User’s Guide
82
The following table describes the labels in this screen.
8.9 Port Setup
Use this screen to configure Switch port settings. Click Basic Setting > Port Setup in the
navigation panel to display the configuration screen.
Figure 41 Basic Setting > Port Setup
The following table describes the labels in this screen.
Table 16 Basic Setting > External Alarm Switch
LABEL DESCRIPTION
Index This is the index number of the external alarm input.
Status This field displays whether the external alarm input has alarms (Alarm) or not (Normal).
Disable displays if the external alarm input is not in use.
Enable Select this check box to have the Switch use the external alarm input.
Name Enter a descriptive name that identifies this alarm input. You can enter up to 31 printable
characters. Spaces are also allowed.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 17 Basic Setting > Port Setup
LABEL DESCRIPTION
Port This is the port index number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable a port. The factory default for all ports is enabled. A port must
be enabled for data transmission to occur.
To Next Page
Loading...
