VES1724-56 User’s Guide 361
CHAPTER 40
Loop Diagnostic
This chapter explains the Loop Diagnostic screen.
40.1 Dual-End Loop Test
Click Management and Loop Diagnostic in the navigation panel to open this screen. Use this
screen to perform dual-end loop test for a port. Refer to Section 7.2.1 on page 54 for the port
status relationship.
Figure 233 Loop Diagnostic
The following table describes the labels in this screen.
Table 171 Loop Diagnostic
LABEL DESCRIPTION
Dual-End Loop
Test
This field displays a port’s current status. The status changes to LD_Testing when you
perform a DELT test and it also displays the time you started the test task and how long the
test has been proceeded.
Show Status Select a port number from the drop-down list box and click Show Status to display the test
result in the table below.
DELT Start This button appears when a port’s status is “Showtime”. Click DELT Start to start the dual-
end loop test between the Switch and the remote devices.
Note: It takes several minutes to complete whole test. Before it’s completed, the status stays at
“LD_Testing”.
To Next Page
Loading...
