Chapter 5 Initial Setup Example
VES1724-56 User’s Guide
44
1 Click Advanced Application > VLAN in the navigation panel and click the Static VLAN link.
2 In the Static VLAN screen, select ACTIVE,
enter a descriptive name in the Name field
and enter 2 in the VLAN Group ID field for
the VLAN2 network.
Note: The VLAN Group ID field in this
screen and the VID field in the IP Setup
screen refer to the same VLAN ID.
3 Since the VLAN2 network is connected to
port 1 on the Switch, select Fixed to
configure port 1 to be a permanent member
of the VLAN only.
4 To ensure that VLAN-unaware devices (such
as computers and hubs) can receive frames
properly, clear the TX Tagging check box to
set the Switch to remove VLAN tags before
sending.
5 Click Add to save the settings to the run-time memory. Settings in the run-time memory are lost
when the Switch’s power is turned off.
5.2.2 Setting Port VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames are
forwarded to the VLAN group that the tag defines.
To Next Page
Loading...
