Chapter 5 Initial Setup Example
VES1724-56 User’s Guide
45
In the example network, configure 2 as the port VID on port 1 so that any untagged frames
received on that port get sent to VLAN 2.
Figure 21 Initial Setup Network Example: Port VID
1 Click Advanced Application >
VLAN in the navigation panel. Then
click the VLAN Port Setting link.
2 Enter 2 in the PVID field for port 1
and click Apply to save your
changes back to the run-time
memory. Settings in the run-time
memory are lost when the Switch’s
power is turned off.
To Next Page
Loading...
