ZyXEL Communications VES1724-56 - DHCP Port Tel

Chapter 35 DHCP
VES1724-56 User’s Guide
312
The following table describes the labels in this screen.
35.3 DHCP Port Tel
Click the Port Tel link in the IP Application > DHCP screen to open the following screen.
Use this screen to configure telephone numbers for each port, if you want to add them into DHCP
option 82 tags. See more information in the IP Application > DHCP > Global (see Section 35.4
on page 313) or IP Application > DHCP > VLAN screen (see Section 35.5 on page 318).
Figure 194 IP Application > DHCP > Port Tel
The following table describes the labels in this screen.
Table 145 IP Application > DHCP > DHCP Status
LABEL DESCRIPTION
Relay Mode This field displays:
• None: if the Switch is not configured as a DHCP relay agent.
• Global: if the Switch is configured as a DHCP relay agent only.
• VLAN: followed by a VLAN ID or multiple VLAN IDs if it is configured as a relay agent for
specific VLAN(s).
Table 146 IP Application > DHCP > Port Tel
LABEL DESCRIPTION
Port This field shows the number of a DSL port. This field also shows the VDSL port bonding group
ID if the port has joined any.
Telephone
number
Enter a string or digits to represent the port’s telephone number. Spaces are not allowed.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.