ZyXEL Communications VES1724-56 - Link Aggregation Control Protocol

Chapter 17 Link Aggregation
VES1724-56 User’s Guide
183
17.5 Link Aggregation Control Protocol
Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to
display the screen shown next. See Section 17.2 on page 180 for more information on dynamic link
aggregation.
Note: Do not configure this screen unless you want to enable dynamic link aggregation.
Figure 109 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 75 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL DESCRIPTION
Table 76 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL DESCRIPTION
Active Select this checkbox to enable Link Aggregation Control Protocol (LACP).
System
Priority
LACP system priority is a number between 1 and 65,535. The switch with the lowest system
priority (and lowest port number if system priority is the same) becomes the LACP “server”.
The LACP “server” controls the operation of LACP setup. Enter a number to set the priority of
an active port using Link Aggregation Control Protocol (LACP). The smaller the number, the
higher the priority level.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple
ports.
LACP Active Select this option to enable LACP for a trunk.
Port This field displays the port number.