Chapter 26 IP Source Guard
VES1724-56 User’s Guide
268
26.7.2 ARP Inspection VLAN Configure
Use this screen to enable ARP inspection on each VLAN and to specify when the Switch generates
log messages for receiving ARP packets from each VLAN. To open this screen, click Advanced
Application > IP Source Guard > ARP Inspection > Configure > VLAN.
Figure 160 ARP Inspection VLAN Configure
The following table describes the labels in this screen.
Burst
interval
(seconds)
The burst interval is the length of time over which the rate of ARP packets is monitored for
each port. For example, if the Rate is 15 pps and the burst interval is 1 second, then the
Switch accepts a maximum of 15 ARP packets in every one-second interval. If the burst
interval is 5 seconds, then the Switch accepts a maximum of 75 ARP packets in every five-
second interval.
Enter the length (1-15 seconds) of the burst interval.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click this to reset the values in this screen to their last-saved values.
Table 120 ARP Inspection Port Configure (continued)
LABEL DESCRIPTION
Table 121 ARP Inspection VLAN Configure
LABEL DESCRIPTION
VLAN Use this section to specify the VLANs you want to manage in the section below.
Start VID Enter the lowest VLAN ID you want to manage in the section below.
End VID Enter the highest VLAN ID you want to manage in the section below.
Apply Click this to display the specified range of VLANs in the section below.
VID This field displays the VLAN ID of each VLAN in the range specified above. If you configure the *
VLAN, the settings are applied to all VLANs.
Enabled Select Yes to enable ARP inspection on the VLAN. Select No to disable ARP inspection on the
VLAN.
To Next Page
Loading...
