Chapter 32 PPPoE IA
VES1724-56 User’s Guide
297
32.6.2 IPPVC Configuration
Click Advanced Application > ADSL Fallback in the navigation panel, and then click the IPPVC
link to display the screen as shown. Use this screen to view and configure IPPVCs for IPoA packets
on individual ports.
Figure 182 Advanced Application > ADSL Fallback > IPPVC
The following table describes the labels in this screen.
Table 138 Advanced Application > ADSL Fallback > IPPVC
LABEL DESCRIPTION
Active Select the check box to enable this IP PVC channel.
Port Enter the number of DSL port for which to configure a channel.
VPI Enter the VPI (Virtual Path Indicator) from 0 to 255 for a channel on a port. The VPI and VCI
identify a channel.
VCI Enter the VCI (Virtual Channel Indicator) from 32 to 65535 for a channel on a port.
PVID Enter the PVID (Port VLAN ID) that the Switch assigns to untagged frames received on this
channel.
This must be the VLAN ID of a VLAN that is already configured. The port that you are
configuring and the uplink port must also be set to the fixed status in the VLAN.
You should also select Tx Tagging for the VLAN to have the Switch tag all the outgoing
frames on the DSL port with this VLAN ID.
Encapsulation Specify the encapsulation type (llc or vc) for this channel.
Priority Assign a default IEEE 802.1p default priority (0 to 7). This is the priority value to add to
incoming frames without a (IEEE 802.1p) priority tag.
Subnet IP Enter the subscriber’s IP address to which the Switch forwards the downstream traffic on
this channel.
To Next Page
Loading...
