Chapter 32 PPPoE IA
VES1724-56 User’s Guide
298
Subnet Mask Enter the subscriber’s subnet mask to which the Switch forwards the downstream traffic on
this channel.
Default Route Enter the IPv4 address of the default gateway to which the Switch forwards frames received
on this channel.
Add Click Add to insert a new IPPVC entry to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the above fields to your previous configuration.
Index This is the index number of the channel on this port. Click a number to edit that channel.
Active This field displays whether the channel is enabled (Yes) or not (No).
Port This field displays the DSL port for which this channel is configured.
VPI This field displays the Virtual Path Identifier (VPI) for this channel.
VCI This field displays the Virtual Circuit Identifier (VCI) for this channel.
PVID This field displays the PVID (Port VLAN ID) to assign to untagged frames received on this
channel.
Encap. This field displays the encapsulation type (llc or vc) for this channel.
Priority This field displays the priority value (0 to 7) that the Switch adds to frames that come in on
this channel without a (IEEE 802.1p) priority tag.
Subnet IP This field displays the IP address for downstream traffic on this channel.
Subnet Mask This field displays the subnet mask for downstream traffic on this channel.
Default Route This field displays the default gateway for this channel.
Delete Select the entries you want to remove and click Delete to remove them.
Cancel Click Cancel to clear the Delete check boxes.
Paging Select Prev or Next to show the previous/next screen or select a page number from the
drop-down list box to display a specific page if all entries cannot be seen in one screen.
Table 138 Advanced Application > ADSL Fallback > IPPVC (continued)
LABEL DESCRIPTION
To Next Page
Loading...
