Chapter 44 CFM Action
VES1724-56 User’s Guide
371
Examples of connectivity test reports are shown next.
Figure 241 Connectivity Test Report Examples
Destination
MAC
Enter the destination port’s MAC address which you want to trace the link to.
Note: The destination must be an MEP port.
Count This is how many times you want to perform for the test.
TransID This is available after you complete a link trace. This is a increasing number to
display how many times the test was done for an MEP port. Enter a TransID and
an EntryNum you get from a test report, and click Show Result to see detailed
information.
EntryNum This is available after you complete a link trace. This displays how many nodes
traced in a test. Enter a TransID and an EntryNum you get from a test report,
and click Show Result to see detailed information.
Transmit Click this to start the connectivity test.
Show Result Select a level, type a VID and MEPID and click this to display the result for a test.
Table 177 CFM Action
LABEL DESCRIPTION
LoopBack Report
Link Trace Report
Show Detail Report
To Next Page
Loading...
