Chapter 8 Basic Setting
VES1724-56 User’s Guide
86
Click the Per Queue link in the Rate Limit Profile Setup screen to display the screen as shown.
Figure 43 Rate Limit Profile Setup > Per Queue
The following table describes the labels in this screen.
Table 19 Rate Limit Profile Setup > Per Queue
LABEL DESCRIPTION
Name Enter a descriptive name (up to 20 characters) for identification purposes.
Queue This is the index number of queues on the Switch. The Switch has eight physical queues.
CIR Select the checkbox and enter the guaranteed bandwidth allowed in kilobits per second (Kbps) for
the incoming traffic flow assigned to this queue through a port. Enter a number between 64 and
1000000.
The sum of commit rate cannot be greater than or equal to the uplink bandwidth.
PIR Select the checkbox and enter the maximum bandwidth allowed in kilobits per second (Kbps) for
the incoming traffic flow assigned to this queue through a port when burst traffic occurs. The
incoming traffic over this peak rate will be discarded. Enter a number between 64 and 1000000.
The peak rate should be greater than the commit rate.
Add Click Add to save the new rule to the Switch. Then a summary table displays in the bottom of the
screen.
Clear Click Clear to clear the fields to the factory defaults.
Index This field displays the index number of the rule. Click an index number to edit the profile.
Name This field displays the descriptive name for the profile.
Applied
Ports
This field displays the port number(s) to which this profile is applied.
You can apply a rate limit profile to a port in the Port Setup screen.
Delete Check the rule(s) that you want to remove in the Delete column and then click the Delete button.
Cancel Click Cancel to clear the selected checkboxes in the Delete column.
To Next Page
Loading...
