Chapter 9 VDSL Setup
VES1724-56 User’s Guide
114
VDSL CPE devices should avoid to transmit data according to your location. See RFI (Radio
Frequency Interference) on page 101.
Figure 59 VDSL RFI Setup
The following table describes the labels in this screen.
Table 38 VDSL RFI Setup
LABEL DESCRIPTION
Start Use these columns below this field to specify the starting frequencies for each RFI band.
Stop Use these columns below this field to specify the ending frequencies for each RFI band.
Band This index number identifies each RFI Band.
Tone Index A tone is a sub-channel of a VDSL band. DMT divides VDSL bands into many 4.3125 kHz
tones.
Enter an increased number (than previous row) from 0 to 4096.
Frequency (kHz) This read-only field displays a frequency that equals the tone index multiple 4.3125
dBm/Hz. This field automatically calculates after a Tone Index value is entered.
Modify Click this to save the settings to the Switch and return to the previous screen.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to clear the fields to the factory defaults.
To Next Page
Loading...
