ZyXEL Communications VES1724-56 - Configuring MAC Based VLAN

Chapter 10 VLAN
VES1724-56 User’s Guide
145
Note: MAC based VLAN applies to un-tagged packets and is applicable only when you use
IEEE 802.1Q tagged VLAN.
Figure 82 VLAN > VLAN Port Setting > MAC Based VLAN
The following table describes the labels in this screen.
Table 55 VLAN > VLAN Port Setting > MAC Based VLAN
LABEL DESCRIPTION
Active Check this box to activate this MAC based VLAN.
Name Enter up to 32 alpha numeric characters to identify this MAC based VLAN.
MAC Address Enter the MAC address in valid MAC address format, that is, six hexadecimal character pairs.
VID Enter the ID of a VLAN with which the untagged frames from the MAC address specified in this
MAC based VLAN are tagged. This must be an existing VLAN which you defined in the
Advanced Application > VLAN screens.
Priority Select the priority level that the Switch will assign to frames belonging to this VLAN.
Add Click Add to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to change the fields back to their last saved values.
Index This is the index number identifying this MAC based VLAN. Click on any of these numbers to
edit an existing MAC based VLAN.
Active This field shows whether the MAC based VLAN is active or not.
Name This field shows the name the MAC based VLAN.
MAC Address This field shows the MAC address for this MAC based VLAN.
VID This field shows the VLAN ID of the frames which belong to this MAC based VLAN.
Priority This field shows the priority which is assigned to frames belonging to this MAC based VLAN.
Delete Click this to delete the protocol based VLANs which you marked for deletion.
Cancel Click Cancel to begin configuring this screen afresh.
Paging Select Prev or Next to show the previous/next screen or select a page number from the
drop-down list box to display a specific page if all entries cannot be seen in one screen.