Chapter 21 Policy Rule
VES1724-56 User’s Guide
203
Outgoing Select Send the packet to the mirror port to send the packet to the mirror port.
Select Send the packet to the egress port to send the packet to the egress port.
Select Set the packet’s VLAN ID to add a VLAN ID to the matched packet or replace the
VLAN ID of the packets with the value you configure in the VLAN ID field.
Metering Select Enable to activate bandwidth limitation on the traffic flow(s) then set the actions to
be taken on out-of-profile packets.
Out-of-profile
action
Select the action(s) to be performed for out-of-profile traffic.
Select Drop the packet to discard the out-of-profile traffic.
Select Change the DSCP value to replace the DSCP field with the value specified in the Out
of profile DSCP field.
Select Set Out-Drop Precedence to mark out-of-profile traffic and drop it when network is
congested.
Select Do not drop the matching frame previously marked for dropping to queue the
frames that are marked to be dropped.
Add Click Add to inset the entry to the summary table below and save your changes to the
Switch’s run-time memory. The Switch loses these changes if it is turned off or loses power,
so use the Save link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel Click Cancel to reset the fields back to your previous configuration.
Clear Click Clear to set the above fields back to the factory defaults.
Index This field displays the policy index number. Click an index number to edit the policy.
Active This field displays Yes when policy is activated and No when is it deactivated.
Name This field displays the name you have assigned to this policy.
Classifier(s) This field displays the name(s) of the classifier to which this policy applies.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
Table 86 Advanced Application > Policy Rule (continued)
LABEL DESCRIPTION
To Next Page
Loading...
