Chapter 25 Authentication and Accounting
VES1724-56 User’s Guide
241
Shared Secret Specify a password (up to 32 alphanumeric characters) as the key to be shared between
the external TACACS+ server and the Switch. This key is not sent over the network. This
key must be the same on the external TACACS+ server and the Switch.
Delete Check this box if you want to remove an existing TACACS+ server entry from the Switch.
This entry is deleted when you click Apply.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Accounting
Server
Use this section to configure your TACACS+ accounting settings.
Timeout Specify the amount of time in seconds that the Switch waits for an accounting request
response from the TACACS+ server.
Index This is a read-only number representing a TACACS+ accounting server entry.
IP Address Enter the IPv4 or IPv6 address of an external TACACS+ accounting server in dotted
decimal notation.
TCP Port The default port of a TACACS+ server for accounting is 49. You need not change this value
unless your network administrator instructs you to do so.
Shared Secret Specify a password (up to 32 alphanumeric characters) as the key to be shared between
the external TACACS+ accounting server and the Switch. This key is not sent over the
network. This key must be the same on the external TACACS+ accounting server and the
Switch.
Delete Check this box if you want to remove an existing TACACS+ accounting server entry from
the Switch. This entry is deleted when you click Apply.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 103 Advanced Application > Auth and Acct > TACACS+ Server Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
