ZyXEL Communications VES1724-56 - Page 247

Chapter 25 Authentication and Accounting
VES1724-56 User’s Guide
247
25.3.2.2 Attributes Used for Accounting Exec Events
The attributes are listed in the following table along with the time that they are sent (the difference
between Console and Telnet/SSH Exec events is that the Telnet/SSH events utilize the Calling-
Station-Id attribute):
25.3.2.3 Attributes Used for Accounting IEEE 802.1x Events
The attributes are listed in the following table along with the time of the session they are sent:
Table 107 RADIUS Attributes - Exec Events via Console
ATTRIBUTE START INTERIM-UPDATE STOP
User-Name Y Y Y
NAS-Identifier Y Y Y
NAS-IP-Address Y Y Y
Service-Type Y Y Y
Acct-Status-Type Y Y Y
Acct-Delay-Time Y Y Y
Acct-Session-Id Y Y Y
Acct-Authentic Y Y Y
Acct-Session-Time Y Y
Acct-Terminate-Cause Y
Table 108 RADIUS Attributes - Exec Events via Telnet/SSH
ATTRIBUTE START INTERIM-UPDATE STOP
User-Name Y Y Y
NAS-Identifier Y Y Y
NAS-IP-Address Y Y Y
Service-Type Y Y Y
Calling-Station-Id Y Y Y
Acct-Status-Type Y Y Y
Acct-Delay-Time Y Y Y
Acct-Session-Id Y Y Y
Acct-Authentic Y Y Y
Acct-Session-Time Y Y
Acct-Terminate-Cause Y
Table 109 RADIUS Attributes-Exec Events via 802.1x
ATTRIBUTE START INTERIM-UPDATE STOP
User-Name Y Y Y
NAS-IP-Address Y Y Y
NAS-Port Y Y Y
Class Y Y Y
Called-Station-Id Y Y Y