Chapter 28 CFM
VES1724-56 User’s Guide
276
Note: You have to create a CFM MD first before you create an MA.
Figure 168 CFM MA
The following table describes the labels in this screen.
Table 123 CFM MA
LABEL DESCRIPTION
MD level Select a level (0-7) you want to create an MA under.
Note: You have to create an MD first by clicking the CFM MD link.
MA Name Type a descriptive name (up to 40 printable ASCII characters) for this MA. This is for
identification purpose.
MA Vlan ID Type a VLAN ID (0-4096) for this MA.
Note: Make sure the VLAN ID has existed before you use it for the MA VLAN ID.
CFM Enable Select this to activate the CFM.
Port This field displays the port number.
Active Select this to activate a port in this MA.
Name This field displays the MA name.
MP Type Select a port type such as MEP (Maintenance End Point) or MIP (Maintenance Intermediate
Point). Or leave it as default (None).
MEP ID Enter an ID number (1-8191) for this MEP port. Each MEP port needs a unique ID number within
an MD. The MEP ID is to identify an MEP port used when you create a CFM action. See Section
44.1 on page 370
.
Add Click Add to add the settings as a new entry in the summary table below.
Cancel Click Cancel to reset the fields.
Clear Click Clear to start configuring the screen again.
Index This field displays the index number for the record in this summary table.
To Next Page
Loading...
