Chapter 8 Basic Setting
VES1724-56 User’s Guide
92
Click the IPv6 Neighbor Setup link in the Basic Setting > IPv6 Setup screen to display the
configuration screen.
Figure 49 Basic Setting > IPv6 Setup > IPv6 Neighbor Setup
The following table describes the labels in this screen.
Table 24 Basic Setting > IPv6 Setup > IPv6 Neighbor Setup
LABEL DESCRIPTION
Static Neighbor Cache Setting
IPv6 Group Select whether the Switch uses the inband or the outband interface to reach the neighbor
device.
VID This field is available when you select Inband in the IPv6 Group field above.
Enter the VLAN ID (1~4094) associated with the specified IPv6 address below.
IPv6 Address Enter an IPv6 address for a static neighbor entry.
MAC Address Enter the MAC address for the static neighbor entry.
Add Click Add to save the new settings to the Switch. The setting displays in the summary table at
the bottom of the screen.
Cancel Click Cancel to reset the fields to your previous configuration.
Index This field displays the index number of a neighbor entry.
Interface This field displays the name of the interface the Switch uses to reach the neighboring
interface.
IPv6 Address This field displays the IPv6 address of the neighboring interface.
MAC Address This field displays the MAC address of the neighboring interface.
To Next Page
Loading...
