Chapter 8 Basic Setting
VES1724-56 User’s Guide
94
Click Basic Setting > SFP Threshold Setup in the navigation panel to display the screen as
shown.
Figure 50 Basic Setting > SFP Threshold Setup
The following table describes the labels in this screen.
Table 25 Basic Setting > SFP Threshold Setup
LABEL DESCRIPTION
User Input
Enable
Select this option if you want to apply the threshold settings configured at the bottom of the
screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Port Index Select an SFP slot of the Switch for which you want to configure the thresholds.
Type This is the type of device operating parameters.
Current This shows the current value of each parameter measured for the installed transceiver.
To Next Page
Loading...
