Error Messages
C-2
Adapter failed while trying to read the adapter configuration
stored on the adapter. Save a new configuration on the adapter.
If the problem persists, swap with a known good EtherLink III,
and try again.
An adapter was configured for EISA mode, but the EISA
configuration utility has not run yet.
An EISA-configured adapter is installed in an ISA computer.
Use the Configure option to reconfigure I/O Base Address setting
to an ISA setting.
Attempting to configure the I/O Base Address for EISA mode.
This is not allowed in an ISA computer.
Automatic configuration only available for ISA bus adapters.
Configuration and Diagnostic Program supports up to six ISA
adapters installed in the computer. More than six were detected.
Either there is no boot PROM installed on the adapter or the
selected boot PROM base address is being used by another
device or software program installed by the computer. Do you
want to save the configuration anyway?
Invalid EISA system configuration. Exit the Configuration and
Diagnostic Program, and run your EISA configuration utility
again.
To Next Page
Loading...
Need help?
General
