Error Messages C-3
The adapter has been changed from EISA mode to ISA mode.
To run Auto Configure in this new mode, you must first exit, and
then rerun your EISA configuration utility.
The adapter has been changed from ISA to EISA mode, or from
EISA mode to ISA mode. Exit this program, place the EISA
configuration diskette in drive A, and reboot the computer.
The adapter is being configured for EISA mode at line x in the
configuration file. This is not allowed on an ISA computer.
The adapter is in EISA mode. Exit the Configuration and
Diagnostic Program and run the EISA configuration utility.
The adapter is in EISA mode. This option can only be set using
your EISA configuration utility.
The adapter was changed from EISA to ISA mode. Exit this
program, place your EISA configuration diskette in drive A, and
reboot the computer.
The adapter was changed from ISA to EISA mode. Exit this
program, place your EISA configuration diskette in drive A, and
reboot the computer.
The adapter’s I/O base address, interrupt request level, and
transceiver type have been successfully selected with Auto
Configure. For your new settings to take effect, save the settings,
exit, and reboot the computer.
To Next Page
Loading...
Need help?
General
