Configuring the ISA Adapter for an EISA Computer 4-7
To reconfigure an ISA adapter, perform the following
steps:
1. Install the EtherLink III adapter in your EISA
computer (refer to Chapter 1 for instructions).
2. Boot your computer under DOS, version 3.1
or later.
3. Make a backup copy of your EtherDisk diskette,
place the backup copy in a floppy drive on your
computer, and make that drive the active drive.
For example, if the diskette drive is A, type the
following command:
A: [Enter]
4. Type at the prompt:
INSTALL [Enter]
5. The first time you use the diskette to install an
adapter, a license screen appears. To accept the
terms and conditions of the 3Com end-user
software license agreement, type the following:
Y
NOTE: To view the full text of the license
agreement, press [F1].
The auto installation screen shown in Figure 4-1
appears.
6. Read the screen and press [Enter].
To Next Page
Loading...
