3D Systems ProX 800 User Manual

3D Systems, Inc.
25
MANUAL OFFLOAD CART
The manual ooad cart is an optional accessory for all ProX 800 models. The ooad cart allows you to easily remove the print
pad when it is loaded with a large or heavy part and transport it to the nishing area where supports are removed and the part
is cleaned before it is cured.
Parts can be ooaded with the manual ooad cart to ensure optimal safety. Refer to the section, “To Remove a Part” on page
62 for information on operating the cart.
LIGHT STACK
Red
• ON, Solid
» E-Stop is pressed
• ON, Flashing
» Fault condition exists, resulting in an aborted
print job.
• OFF
» Normal operating condition
Amber
• ON, Solid
» Printer is being serviced
• ON, Flashing
» User warning or alert
• OFF
» E-Stop is pressed
Green
• ON, Solid
» Print Job is in progress
• ON, Flashing
» Manual operation in progress
• OFF
» E-Stop is pressed or normal
operating conditions

3D Systems ProX 800 Specifications

General

Brand	3D Systems
Model	ProX 800
Category	3D Printers
Language	English