3D Systems ProX 800 User Manual

3D Systems, Inc.
54
ProX 800
Setting the Ooad Position
If the Manual Ooad needs to be adjusted, you can do so by following these steps:
1. Select Edit from Move Distance.
ProX 800
1. The editing keypad pops up. Type in the amount to move (ex. “.5” will move print pad up ½”). This is a good place to start.
2. Press Set.
3. Repeat these steps until the print pad is far enough up to get the Manual Ooad Cart under it without damaging the
recoater or to reach the timing plate. Refer to the section, “To Remove a Part,” on page 62 .
NOTE: If the print pad is too high, you can reverse it by typing .5 > - (minus sign) > Set in the editing keypad to
set a negative value. This moves the print pad down ½”.

3D Systems ProX 800 Specifications

General

Brand	3D Systems
Model	ProX 800
Category	3D Printers
Language	English