3D Systems, Inc.
42
DRAWING SETTINGS SCREEN
The Drawing Settings Screen allows the user to view and set the center point of the print area. This shifts the entire range of the
imaging system by the amount indicated. The image is automatically centered in the middle of the print pad. If the user wants
to shift this position, they can do so by editing the X and Y values.
RESTART BUILD WIZARD
In GUI v1.1.5443, this feature provides
the user more control over the process
of restarting a build that has been
interrupted.
1. Select Restart Last Job from
the status screen.
NEW FUNCTIONALITY FOR GUI V1.1.5443
Current Position: Displays the current X Position.
Current Position: Displays the current Y Position.
X Value: This is where the current X Value can be edited. Select the key to edit. This will shift the entire range of the
imaging system by the amount indicated.
Y Value: This is where the current Y Value can be edited. Select the key to edit.
Set Offset: Saves the current Offset values.
A
B
A
B
To Next Page
Loading...
Need help?
General
