3D Systems ProX DMP 300 - Page 49

453D SYSTEMS, INC. PN:80-D27 Rev.B
Step 8 : Loading of the manufacturing le and inerting
This step consists of :
• Selecting the manufacturing le (*.FAB3 format) created with ProX DMP Manufacturing, standalone software,
• Inerting the manufacturing chamber.
1. Click on the folder icon to launch the le browser (1).
2. Select the manufacturing le and click on "Load le" (2).
The Preparation Assistant will then return to the previous page. The inerting phase should then be initiated.
1
2