Viewing and Seting Controller Policies
www.3ware.com 117
Viewing and Seting Controller Policies
The following controller-wide policies can be adjusted as appropriate for your
equipment.
•
Auto-Rebuild. Determines whether the Auto-Rebuild policy is enabled or
disabled. When disabled, degraded units can only be rebuilt with
designated spares. When enabled, the controller firmware will attempt to
rebuild a degraded unit if there is no spare, using either an available drive
or a failed drive. Applies only to 9550SX and 9590SE controllers.
•
Auto-Carving. Determines whether the auto-carving policy is enabled or
disabled. When it is enabled, any unit larger than a specified size (known
as the carve size) is created as multiple volumes that can be addressed by
the operating system as separate volumes. The default carve size is 2 TB.
This auto-carving feature is sometimes referred to as multi-LUN, where
each volume that is created is referred to as a “LUN.”
•
Carve Size. (Referred to as Carving Factor in 3BM) Sets a size for
dividing up units into volumes when Auto-Carving is enabled. This
setting can be between 1024 and 2048 GB.
•
Staggered spin-up. Spin-up allows drives to be powered-up into the
Standby power management state to minimize in-rush current at power-up
and to allow the controller to sequence the spin-up of drives. Compatible
drives are sent a spin up command as defined by the
Number of drives
per spin-up
and Delay between spin-up settings. These policies can
only be set in 3BM and CLI.
•
Number of drives per spin-up. Number of drives that will spin up at
the same time when the controller is powered up, if staggered spin-up
is enabled. From 1 to x, depending on the number of ports on the
controller.
•
Delay between spin-up. The delay time (in seconds) between drive
groups that spin up at one time on this particular controller, if
staggered spin-up is enabled.
•
Export JBOD (unconfigured) disks. This setting indicates whether
JBOD disks should be exported to the operating system. JBOD
configuration is strongly discouraged for newly added disks on the 9000
series controller, in favor of Single Disk, so by default, this setting is
disabled. If you have a JBOD configuration from a 7000/8000 controller
that you want to use on the 9000 controller, you should enable this setting.
This policy can only be set in 3BM and CLI.
•
Disable write cache on degraded array. For 9500S controllers,
indicates whether write cache will be automatically disabled on a unit if it
becomes degraded. (This option does not apply to 9550SX and 9590SE
controllers; the feature is integrated into the StorSave policy.)
To Next Page
Loading...
