www.3ware.com 29
4
Driver Installation
The final steps in setting up your RAID units are to load the 3ware driver and
make the units available to your operating system.
• If the unit you have created will be your system's boot device, you install
the driver for the controller as you install the operating system.
• If the operating system is already installed on a unit connected to another
controller or to the motherboard, you start the operating system and then
install the driver.
Details for both situations are described in this chapter. Driver information is
organized by operating system:
• “Driver Installation Under Windows” on page 30
• “Driver Installation Under Linux” on page 38
• “Driver Installation Under FreeBSD” on page 49
To Next Page
Loading...
