Chapter 4. Driver Installation
48 3ware Serial ATA RAID Controller User Guide
Note: If the kernel driver module installation fails, confirm that
the correct driver was installed from the CD-ROM. If a driver
is not available for your system, you will need to compile your
own driver. For more information, see 3ware knowledgebase
article 14546 http://www.3ware.com/kb/
article.aspx?id=14546.
6Type:
/sbin/depmod -a
7Type:
/sbin/mkinitrd
8 If you are using the GRUB boot loader, you are finished.
If you are using the LILO boot loader, run LILO to update the boot record
on disk by typing the following:
/sbin/lilo
The output should be similar to:
Added linux *
Compiling a 3ware Driver for Linux
If you are using a Linux distribution for which there is not a compiled driver
available from 3ware, you can copy the source from the 3ware software CD or
download the source from the 3ware website and compile a new driver. For
more information, see 3ware knowledgebase article 14546
http://www.3ware.com/KB/article.aspx?id=14546.
To Next Page
Loading...
