Chapter 6. 3ware Disk Manager (3DM 2)
82 3ware Serial ATA RAID Controller User Guide
To set up event notification
1 Click
3DM 2 Settings on the menu bar.
2In the
E-mail Notification section of the 3DM 2 Settings Page, enter or
change the settings you want.
• Enable or Disable all notifications.
• Set the severity level of events for which e-mail notifications are sent.
• Specify the email address of the sender. This will appear in the
“From” field of the e-mail.
• Enter the e-mail address(es) to which notifications are sent. (Separate
multiple addresses with a comma (,) or a semicolon (;).
• Enter the SMTP server name or IP of your mail server.
3Click
Save E-mail Settings.
To send a test message
You can send a test message to make sure you’ve entered the e-mail
notification settings correctly.
• Click
Send Test Message.
Enabling and Disabling Remote Access
When remote access is enabled, a user can connect to 3DM over the internet
or an intranet, to check status or administer the controller and associated
drives.
If remote access is disabled and a user attempts to connect to 3DM remotely,
they will see the following error message: “Remote Access to 3DM has been
disabled. Please connect using the local machine by entering “localhost” in
the URL bar.”
Remote access can be enabled or disabled on the 3DM 2 Settings page.
To enable or disable remote access
1 Click
3DM 2 Settings on the menu bar.
2In the
Remote Access section of the 3DM 2 Settings Page, select either
Enabled or Disabled in the Allow Remote Connections field.
The page refreshes, and a message at the top of the screen confirms that
remote access has been enabled or disabled.
To Next Page
Loading...
