Exiting the 3BM Configuration Utility
www.3ware.com 57
Note: If you have a combination of 7000/8000-series and
9000-series controllers in your system, the 7000/8000-series
controllers are not listed on the selection screen shown in
Figure 25. Instead, an additional BIOS summary will appear
for the 7000/8000-series controller, similar to Figure 24. To
access the BIOS utility for the 7000/8000-series board, press
Alt-3 when the information for that controller appears.
Although similar to 3BM, some screens and features are
different for the 7000/8000-series. For detailed information,
see the version of the 3ware Escalade ATA RAID Controller
User Guide that supports the 7000 and 8000 series controllers.
If you have two 9000 controllers that have different versions of
the BIOS installed, they will also appear in different BIOS
summaries, and will launch different versions of 3BM.
Exiting the 3BM Configuration Utility
When you are ready to exit the 3BM configuration utility, you have the option
to save the configuration changes you have made, or to discard the changes.
To save your configuration modifications
1 Press the F8 or Esc key.
A list of affected drives appears, and a messages ask you to confirm the
configuration.
2Type
Y.
The booting process resumes.
To exit without saving changes
1 Press Esc.
2 If you have unsaved changes, 3BM will ask you whether you want to save
the changes and exit, or exit without saving the changes.
If you want to exit without saving changes, type
N.
If you change your mind and want to save the changes, type
Y.
To Next Page
Loading...
