www.3ware.com 127
8
Configuring Units
A unit is any configured disk or array of disks connected to your 3ware RAID
controller.
This section includes instructions for performing the following configuration
tasks:
• Configuring a New Unit
• Creating a Hot Spare
• Naming a Unit
• Setting Unit Policies
• Enabling and Disabling the Unit Write Cache
• Setting Auto-Verify for a Unit
• Setting Continue on Source Error During Rebuild
• Enabling and Disabling Queuing for a Unit
• Setting the StorSave Profile for a Unit
• Changing An Existing Configuration
(RAID Level Migration or Online Capacity Expansion)
• Deleting a Unit
• Removing a Unit
• Moving a Unit from One Controller to Another
• Adding a Drive through 3DM
• Removing a Drive
• Rescanning the Controller
To Next Page
