Chapter 8. Configuring Units
144 3ware Serial ATA RAID Controller User Guide
To enable or disable unit write cache through 3DM
1 Choose
Management > Controller Settings from the menu bar in 3DM.
2In the
Unit Policies section of the Controller Settings Page, check the
Write Cache box to enable it for the designated unit.
The page refreshes, and a message at the top confirms the change you
have made.
To enable or disable unit write cache through 3BM
1 At the main 3BM screen, select the unit by highlighting it and pressing
Enter.
An asterisk appears in the left-most column to indicate that it is selected.
2
Tab to the Maintain Unit button and press Enter.
3 On the pop-up menu, select
Configure and press Enter.
4 In the Configure Disk Array screen, Tab to the field Write Cache
Settings
.
Figure 62. Unit Write Cache State in 3BM
The current setting—Enabled or Disabled—is shown. (The initial default
setting is for write cache to be enabled.)
5 Press
Enter to display the choices, use the arrow keys to select the setting
you want, and press
Enter again to choose it.
To Next Page
Loading...
