AEN Messages
www.3ware.com 235
034h Migration failed
This AEN is sent when migration of a unit fails. Look at the Alarms page for
other entries that will give you an idea of why the migration failed (such as a
drive error on a specific port).
035h Migration completed
This AEN is sent when migration of a unit is complete. The new capacity is
now ready to be used. If the capacity of the array did not change, then you
don't need to do anything else. If the capacity of the migrated array is larger,
please refer to the part of this document on migration for information on how
to change the file system to use the new capacity.
036h Verify fixed data/parity mismatch
This AEN is sent by the controller when a verify error is found (parity
inconsistency for RAID5/50 or data mismatch for RAID1/10 configuration)
and recovered. If the error is not recovered the AEN_VERIFY_FAILED is
returned instead.
037h SO-DIMM not compatible
This AEN will be sent if an incompatible SODIMM memory has been
connected to the controller. In this case, the controller is inoperable.
038h SO-DIMM not detected
This AEN will be sent if there is no SODIMM memory connected to the
controller. In this case, the controller is inoperable.
039h Buffer ECC error corrected
This AEN will be sent when the controller has detected and corrected a
memory ECC error.
03Ah Drive power on reset detected
If the controller detects that a drive has been power-cycled, it will send this
AEN. The controller may degrade the unit (if possible).
03Bh Rebuild paused
This AEN will be sent when the rebuild operation is paused.
Rebuilds are normally paused for ten minutes after a system first boots up and
during non-scheduled times when scheduling is enabled.
To Next Page
Loading...
