Working in the 3BM Screens
www.3ware.com 59
data that needs to be updated before your 3ware 9000 series controller can
use them. (If you want to move a unit from a 7/8000 controller to the 9000
controller, you must convert the drives first. For more information, see the
section “Moving a Unit from One Controller to Another” on page 163.)
When some of the drives are remaining from a unit, you can power down
and add the missing drives to complete the unit. To use drives that are
listed here in other units, you must first delete them. For more
information, see “Deleting a Unit” on page 157.
If any of the sections are not shown, it means that there are no items of that
type connected to the controller.
Table 6 lists how to move around and select information in the 3BM screens.
When these commands are available in 3BM, they appear at the bottom of the
3BM screen.
Table 6: Working in 3BM 2
To do this Use these keys
Move between units or drives in a list,
between fields, and between buttons
Up and Down Arrow Keys
OR
Left and Right Arrow Keys
OR
Tab and Shift+Tab
Select (or unselect) what is currently
highlighted.
A selection may be a drive in a list of
drives, a button at the bottom of the
screen, or a field in the middle of the
screen.
In lists, an asterisk appears to the left of
selected drives or units
Enter or the Spacebar
Display a drop-down list of available
choices in a field
Enter
Move between choices in a field list Up and Down Arrow Keys
Select all available drives Alt+A
In the list of units, expand a selected unit
to see any subunits and drives in the unit,
or contract it to see only the heading
again. (9550SX and 9590SE controllers
only)
Shift+
Shift-
To Next Page
Loading...
