DECT over IP
®
147
DECT over IP/OpenMobility Managers Login Page
The WLAN function and the function of the DECT over IP/OpenMobility Manager
cannot be used simultaneously on the same DECT over IP base station, so you will
always need at least two DECT over IP base stations. The WLAN settings are then
made as follows:
1. Set up the existing DECT over IP base stations in theOpenCom 100’s Configurator.
Go to the DECT over IP Manager’s Web Configurator.
2. On the WLAN Profiles page, configure at least one set of settings (see below
under: Setting up a WLAN Profile). Note down the password you have used (“Pre-
Shared Key”), so that you will be able to use it again later when setting up wireless
user terminals or notebooks.
3. Assign the desired WLAN profile on the Radio Fixed Parts page. Click on spanner
symbol ( ) on the left next to the relevant DECT over IP base station. Under
WLAN Settings select the number of the configured WLAN Profile. Confirm your
settings with OK. You can use one profile for multiple DECT over IP base stations.
You can now use the WLAN function of your WLAN-enabled DECT over IP base sta-
tions and set up the user terminals as required.
Setting up a WLAN Profile
The WLAN function of the RFP 42/43 DECT over IP base station also includes such
rarely-required features as networks for large company premises or airports. In this
guide we will, for the sake of brevity and clarity, describe only those features required
for secure standard operation.
To Next Page
Loading...
Need help?
General
