ABB 620 Series - Page 9

LD0.ROVPTOV3 Residual overvoltage protection - stage 3.......35
LD0.XBGGIO105 Physical binary I/O signal (status only)...........35
LD0.XHBGGIO105 Physical binary I/O signal (status only)........36
LD0.XGGIO100 Physical binary I/O signals (status only)...........36
LD0.XAGGIO130 Physical binary I/O signals (status only).........36
LD0.XBGGIO115 Physical binary I/O signals (status only).........37
LD0.MDSOPT1 Generic operation time supervision...................37
LD0.MDSOPT2 Generic operation time supervision...................37
LD0.MNSPTOC1 Negative-sequence overcurrent
protection for motors (1)..............................................................38
LD0.MNSPTOC2 Negative-sequence overcurrent
protection for motors (2)..............................................................38
LD0.JAMPTOC1 Stalled motor protection ..................................38
LD0.STTPMSU1 Motor startup supervision (1)...........................38
LD0.PREVPTOC1 Phase reversal protection.............................38
LD0.MPDIF1 Motor differential protection (1)..............................39
LD0.MPTTR1 Motor thermal overload protection........................39
LD0.EMSGAPC1 Emergency start .............................................39
LD0.LOFLPTUC1 Loss of load protection...................................39
LD0.LOFLPTUC2 Loss of load protection...................................39
LD0.ARCSARC1 Fault arc protection - stage 1...........................40
LD0.ARCSARC2 Fault arc protection - stage 2...........................40
LD0.ARCSARC3 Fault arc protection - stage 3...........................40
LD0.EFLPTOC1 Non-directional earth-fault and sensitive
earth-fault protection - low stage 1..............................................40
LD0.EFHPTOC1 Non-directional earth-fault and sensitive
earth-fault protection - high stage 1.............................................41
LD0.EFIPTOC1 Non-directional earth-fault and sensitive
earth-fault protection - instantaneous stage 1.............................41
LD0.PHIPTOC1 Phase overcurrent protection -
instantaneous stage 1 ................................................................41
LD0.PHLPTOC1 Phase overcurrent protection - low stage
1...................................................................................................41
LD0.DEFHPDEF1 Directional earth-fault protection - high
stage 1.........................................................................................42
LD0.DEFLPDEF1 Directional earth-fault protection - low
stage 1.........................................................................................42
LD0.CMMXU1 Phase currents (1) limit supervision....................42
LD0.RESCMMXU1 Residual current (1) limit supervision...........42
LD0.VMMXU1 Phase voltage (1) limit supervision......................43
LD0.RESVMMXU1 Residual voltage (1) limit supervision...........43
LD0.CMMXU2 Phase currents (2) limit supervision....................43
CTRL.Cxxxxx1 Circuit breaker (1) CB object and failure
protection.....................................................................................43
Table of contents
REM620 3
Point List Manual