ABB ACS880 - Page 209

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
1 = 1 = 10000h…FFFFh
Drive not ready /
unit32
Displays the current state of drive control.Drive control state9.9
0Drive is not ready for operation.Drive not ready
1No motor ID run done. Necessary to run in DTC mode.ID run undone
2Drive is stopped.Drive stopped
3A fault is active.Fault active
4Drive is in Local control.Local control
5Jogging enable signal is On.Jog mode
6Control location EXT1 is active.Ext1 running
7Control location EXT2 is active.Ext2 running
8Drive is stopping the motor as per deceleration ramp
time settings.
Stopping
9Stopping after receiving an emergency stop command.Em stop active
10Drive is running in constant speed mode.Constant speed
0.00 A / real32Displays actual drive output current.Drive output current9.11
100 = 1 A / 100 = 1 ADrive output current.0.00 ... 30000.00 A
0.00 A / real32Displays the actual motor current estimate based on
transformer ratio and sine-filter settings.
Motor current
estimated
9.13
100 = 1 A / 10 = 1 AEstimated motor current.0.00 ... 30000.00 A
0.00% / real32Displays estimated actual motor current in %.Motor current %9.14
100 = 1% / 10 = 1%Estimated motor current.0.00 ... 30000.00%
0.00 V / real32Displays the actual motor voltage estimate based on
transformer ratio setting.
Motor voltage
estimated
9.15
100 = 1 V / 10 VEstimated motor voltage.0.00 ... 30000.00 V
0.00 Hz / real32Displays the frequency reference currently produced
by the ESP control program.
Frequency reference
used
9.21
100 = 1 Hz / 10 = 1 HzESP frequency.-600.00 ... 600.00 Hz
0.00% / real32Displays ESP speed/frequency reference in percent
scale.
Speed reference
percentage
9.22
100 = 1% / 10 = 1%Speed reference.-1200.00 ...
1200.00%
0.00 rpm / real32Displays the speed reference currently produced by the
ESP control program.
Speed reference
used
9.23
10 = 1 rpm / 10 = 1
rpm
Speed reference.-30000.0 ... 30000.0
rpm
0.00 min / real32Displays the time remaining before restart delay
function stops inhibiting the user start command.
Restart delay
remaining
9.41
10 = 1 min / 10 = 1
min
Restart delay time.0.0 ... 30000.0 min
Parameters 209