ABB ACS880 - Pump Cleaning

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Enables pump cleaning function.Pump cleaning81
See section xxx.
ESP CW bit 12 /
unit32
Defines the source for the Cleaning function enable
signal.
The function requires enable signal ON + some of the
triggers active. This creates a cleaning request. If both
conditions are achieved, then the drive is started.
Pump cleaning
enable
81.01
The ESP control program will first perform the cleaning
routine as per settings in parameters 81.20 Number of
cleaning cycles...81.48 Supervision high delay. From the
last cleaning step, the function will automatically
continue to production operation.
Note: Cleaning function cannot be triggered when
motor is running.
0Backspin speed observer function is disabled.Not selected
1Backspin speed observer function is enabled.Selected
2Digital input DI1 (10.2 DI delayed status, bit 0).DI1
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
4Digital input DI3 (10.2 DI delayed status, bit 2).DI3
5Digital input DI4 (10.2 DI delayed status, bit 3).DI4
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
10Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
11Digital input/output DIO2 (11.2 DIO delayed status, bit
1).
DIO2
12Parameter 74.1 ESP control word (page 519), bit 12 status
controls enable/disable status of the function.
ESP CW bit 12
See Terms and abbreviations (page 169).Other [bit]
- / unit16Defines the control word for the pump cleaning
function.
Pump cleaning
option sel
81.02
Each bit of this parameter defines either triggering
options or control options of certain extensions for
the cleaning operation.
Reservedb0
Cleaning can be requested by the manual trigger.Manual triggerb1
See parameter 81.11 Manual trigger source.
Cleaning can be requested by the time trigger.Time triggerb2
See parameter 81.19 Time trigger.
Reservedb3
Enables starting speed. See parameter 75.15 Starting
speed.
Allow start-up speedb4
Enables kick start mode. See parameter 75.50 Kick start
enable (page 528).
Allow kick-startb5
552 Parameters