ABB ACS880 - Page 553

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Enables current pulse start mode. See parameter 75.60
Current pulse start mode enable.
Allow current pulseb6
Enables cleaning acceleration boost. See parameter
81.35 Acceleration boost current.
Acceleration boostb7
Reservedb8...9
Enables supervision for the maximum allowed number
of cleaning.
Max cleaning
supervision
b10
Allows low level supervision automatically interrupt the
pump cleaning procedure.
Supervision lowb11
Allows high level supervision to skip current cleaning
step cycle.
Supervision highb12
Reservedb13
Sets use-style of the manual trigger to initiate pump
cleaning procedure on source signal level.
Manual trig levelb14
Invert cleaning procedure speed reference sign for the
both steps.
Invert ref signb15
1 = 10000h…FFFFh
ESP CW bit 12 /
unit32
Defines source for the Manual trigger signal necessary
to activate the cleaning operation.
To activate triggering option, set parameter 81.02
Pump cleaning option sel to bit 1.
Note: The triggering style can be controlled with
parameter 81.02 Pump cleaning option sel, bit-14.
There are two possible use cases for cleaning manual
trigger.
• When bit-14 is set to 0, cleaning function request
is created only on the rising edge of the source
signal. Note, that the trigger signal must remain
ON for the cleaning request.
• When bit-14 is set to 1, cleaning function request
is defined by the source signal level status. If the
trigger signal is ON all the time, then cleaning
operation will be performed at every start.
Manual trigger
source
81.11
0Manual trigger source is not selected.Not selected
1Manual trigger source is selected.Selected
2Digital input DI1 (10.2 DI delayed status, bit 0).DI1
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
4Digital input DI3 (10.2 DI delayed status, bit 2).DI3
5Digital input DI4 (10.2 DI delayed status, bit 3).DI4
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
10Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
Parameters 553